品牌：优派
系统：全车防锈
底盘装甲
产品编号： 1000ML
企业标准：Q/YK 016-2009
仅供4S店使用
产品特性：
1. 保护车底金属与水隔离，避免生锈；
2. 堵塞部件联接缝隙，紧扣螺丝避免行驶中脱落；
3. 降低车底噪音，防止砂石撞击损害；
4. 提高车内行驶舒适感，延长车辆使用寿命。
使用方法：
1.将车底需喷涂的部件彻底清洁，如有锈迹应铲除、砂光，达到无尘，无水，无油，无蜡迹将不需喷涂的部位（排气管、发动机、水箱、弹簧、空调冷凝器等）进行严密覆盖。
2.充分摇动本品约2分钟，打开灌盖，去除封口，插入本厂专用喷枪，连接0.6-0.8Mpa压缩空气。在距离喷涂表面约25cm处，来回均匀喷涂。
3.为防止流痕和松垂，建议分三次喷涂。在第一次喷涂完成后，对孔洞，裂缝处使用车腻子填封、刮平；待前一次喷涂干燥后（不少于15分钟）再进行喷涂。厚度达到1.5mm以上隔音效果明显。
4.本品未干固前可用汽油清洗
注意事项：
眼睛接触,请立即用大量的清水清洗,并立即就医;
如果误食,不要催吐,立即就医,并出示该物品的盛装容器或标签。
properties:
1, This product USES the new technology synthesis resin, safeenvironmental protection;
2 ,Protect the bottom metal from water to avoid rust;
3, Plug the joint gap of the parts, fasten the screws to avoidfalling off during driving;
4, Remove the noise from the bottom of the car to prevent theimpact of sand and stone;
5,Improve the comfort of the vehicle and extend the service life ofthe vehicle.
Usage :
1. To spray parts of the car will thoroughly clean, if have shouldbe razed and rust sanding, to clean, no water, no oil, no wax markwill need not spraying parts (the exhaust, engine, water tank,spring, air conditioner condenser, etc) closelycovered.
2. Fully moved this article about 2 minutes, open the irrigationcover, remove the seal and insert the factory special spray gun,connection0.6-0.8 Mpa compressed air. In the distance spraying thesurface of about 25 cm place, spray evenly back and forth.
3. To prevent flow mark and baggy, suggested in three spraying. Inthe first time after the completion of the spraying of hole, crackin car use, to blow be bored with child fill seal flat; For a timeafter dry before spraying (not less than 15 minutes) and thenspraying. 1.5 mm thickness above sound insulation effect isobvious.
4. This product did not work to solid available before gasoline toclean
Note:
Avoiding Any Eye Contact ,if contact, please immediately withplenty of clean flowing water and seek medical adviceimmediately;
If swallowed, don't spits, seek medical advice immediately and showthis container or label the dress items.
